Sensor Tag

 

Viewing and Changing Instrument Information
1. Open the menu bar for the instrument by taping on the instrument cell. 

2. Tap info in the menu bar, this will take you to the instrument information page. 

Here you can view the instrument information such as:

Manufacturers Name
RSSI

Serial Number
Model Number
Firmware Revision
Hardware revision

 
3. To change the name; tap the name and type a new name, then tap done. This will save a new name and will be remembered by DataWorks if the instrument is disconnected and reconnected. ​​
 
Calibrating your Sensor Tag

DataWorks enables you to calibrate the magnetometer and gyroscope for your Sensor Tag, with a simple one-touch procedure. 

1. Open the menu bar for the Sensor Tag by tapping on the instrument on the main page. 


2. Tap calibrate in the menu bar. 
3. You are taken to the calibration page, here will be two clearly labeled buttons for the calibration process. 
Calibrating the Sensor Tag for the Magnetometer and Gyroscope, will make its current physical position 0 for the X, Y, Z components.

4. To calibrate, simply tap the Calibrate Magnetometer and/or Calibrate Gyroscope, this will zero the components within seconds.
To ensure it has been calibrated, leave the Sensor Tag stationary, and check the values on the main page are 0.  

Did you find this article helpful?